Is the AMG Exam Hard? (Honest 2026 Breakdown)
The AMG exam is moderately hard — not because the questions are tricks, but because they span 12 subject areas and reward calculation over memorization. You get 60 multiple-choice questions, 2 hours, and need 70% (42 correct) to pass. Candidates who fail usually underprepared the math-heavy subjects: basic electricity and weight-and-balance calculations.
Try 3 real AMG questions
Real questions from the AMG bank, with the cited explanation for every answer. Tap an answer to check it.
1. A 28-volt DC circuit contains a single 7-ohm resistor. How much current flows in the circuit?
Ohm's Law states current equals voltage divided by resistance (I = E/R). 28 volts ÷ 7 ohms = 4 amperes.
Source: Aviation Maintenance Technician Handbook—General (FAA-H-8083-30B), Chapter 12, Fundamentals of Electricity & Electronics, Ohm's Law (Resistance)
2. An aircraft cabin light draws 5 amperes from the 28-volt DC bus. How much electrical power does the light consume?
Electrical power equals voltage multiplied by current (P = E × I, Watt's Law). 28 volts × 5 amperes = 140 watts.
Source: Aviation Maintenance Technician Handbook—General (FAA-H-8083-30B), Chapter 12, Fundamentals of Electricity & Electronics, Power and Energy / Power Formulas
3. Three resistors of 10 ohms, 20 ohms, and 30 ohms are connected in series across a voltage source. What is the total resistance of the circuit?
In a series circuit, total resistance is the sum of the individual resistances: 10 + 20 + 30 = 60 ohms.
Source: Aviation Maintenance Technician Handbook—General (FAA-H-8083-30B), Chapter 12, Fundamentals of Electricity & Electronics, Series Circuits / Resistance in Series
What the AMG exam actually looks like
The AMG (Aviation Mechanic — General) is the first of the three FAA written tests on the path to an Airframe and Powerplant certificate. Its format is published openly in the FAA's Companion Guide to the Aviation Mechanic ACS:
| Test | Questions | Time | Pass score |
|---|---|---|---|
| AMG (General) | 60 | 2.0 hours | 70% (42 correct) |
| AMA (Airframe) | 100 | 2.0 hours | 70% (70 correct) |
| AMP (Powerplant) | 100 | 2.0 hours | 70% (70 correct) |
Source: FAA-G-ACS-1 Companion Guide, Ch. 3, Written Test Description table
Two things jump out. First, the pacing is generous: 2 hours for 60 questions works out to 2 minutes per question — far more breathing room than most professional exams give you. Second, the pass bar is 70%, a fixed standard set by regulation (14 CFR 65.17), not a curve. You are not competing against other test-takers; you are competing against the standard.
To sit for the test, you need an authorization document — either an authenticated document from an FAA-approved Aviation Maintenance Technician School, or an FAA Form 8610-2 endorsed by a Flight Standards District Office (FAA Airman Knowledge Testing Matrix).
What's actually on the AMG exam
The test samples 12 subject areas defined in the Airman Certification Standards (FAA-S-ACS-1, Section I). The FAA publishes how much of the test each area can make up:
| Subject area | Share of the test |
|---|---|
| Mathematics | per ACS weights |
| Physics | per ACS weights |
| Basic Electricity | 5–15% (heaviest band) |
| Aircraft Drawings | 5–10% |
| Weight and Balance | 5–10% |
| Fluid Lines and Fittings | 5–10% |
| Materials and Hardware | 5–10% |
| Cleaning and Corrosion Control | 5–10% |
| Inspection Concepts and Techniques | per ACS weights |
| Regulations | per ACS weights |
| Human Factors | per ACS weights |
| Ground Operations and Servicing | 5–15% |
Source: FAA-G-ACS-1 Companion Guide, percentage-of-test-questions table and written test description; subject list per the FAA Aviation Mechanic ACS (FAA-S-ACS-1, Section I, incorporated by reference into 14 CFR 65.75)
The weight bands matter because they tell you where your study hours earn the most. Electricity and Ground Operations top out at 15% each — on a 60-question test, that's up to 9 questions per area. Miss most of those and the 42-correct bar gets much harder to clear.
What makes the AMG exam hard
It's the math, not the memorization. The AMG's hardest questions are the ones that make you calculate: electrical circuits, weight-and-balance arithmetic, physics problems. Basic Electricity is both the heaviest-weighted area and the most calculation-dense — Ohm's law, power, series and parallel circuits, capacitor and inductor behavior. Weight and Balance adds a second calculation cluster on top. If your algebra is rusty, these sections cost you real points, because every calculation question has exactly one right answer and no partial credit (FAA-G-ACS-1 Companion Guide).
It's broad. Twelve subject areas means there is no corner you can skip entirely. A test-taker who's strong on regulations but weak on drawings can bleed points in areas they never bothered to study.
Figure-based questions. The written test uses the FAA-CT-8080-4G testing supplement — a booklet of figures and diagrams you reference during the exam (FAA Airman Knowledge Testing Matrix). Questions that point at a diagram reward familiarity with the supplement itself; if you've never opened it, you'll burn time orienting yourself mid-test.
The "first test" factor. For most candidates, the AMG is the first FAA knowledge test they've ever taken. Test-center procedure — check-in, the computer interface, time management — is all new. That's a fixable problem, but it explains why the General feels harder than it structurally is.
What makes the AMG exam fair
Honesty cuts both ways, so here's the other half of the picture.
Nothing on the test is secret. The FAA publishes the subject areas, the weight ranges, the passing score, and the question format. Commercial prep companies build entire businesses around the fact that this blueprint is public. You always know exactly what you're up against.
The question format is simple. Every question is objective multiple-choice with a single correct response, and each question stands alone — a correct answer on one never depends on another (FAA-G-ACS-1 Companion Guide, Ch. 3). No multi-part scenarios, no "select all that apply," no case studies that chain across items.
The pacing is on your side. Two minutes per question is enough to work a calculation on scratch paper, double-check it, and move on. Treat the clock as a solved problem and the heavy subjects as the whole game.
Failure isn't fatal. If you fail, you get an Airman Knowledge Test Report showing the ACS codes for the areas you missed, and you can retest 30 days later — or sooner if you get a signed statement of additional instruction from a certificated airman (FAA-G-ACS-1 Companion Guide, Retests; FAA mechanic FAQ). The retest rules are built around this — treat the AKTR codes as your study plan.
How to beat the AMG exam
- Aim your study at the weights. Spend the most time on Basic Electricity and Ground Operations and Servicing — they carry up to 15% each. Then Weight and Balance, Aircraft Drawings, and Fluid Lines and Fittings at up to 10%.
- Drill the calculations. Work Ohm's law, power, and weight-and-balance problems until the arithmetic is automatic. The exam doesn't test whether you've seen the formula — it tests whether you can execute it under time.
- Practice with the figures. Study using the FAA-CT-8080-4G supplement so diagram-based questions feel familiar on test day (FAA Airman Knowledge Testing Matrix).
- Budget 2 minutes per question, then bank time. If a question eats more than 2 minutes, mark it and move on. With 42 correct needed out of 60, you can afford to miss 18 — but you can't afford to leave questions blank because you ran out of clock.
- Take timed practice tests. The format is public and the pacing is the skill. Practice under the same 2-hour constraint until finishing early feels normal.
What this article can't do for you
Reading about the 12 subject areas won't tell you which ones you are weak in. A guide can point at the heavy weights; it can't diagnose your electricity math. The honest next step is a timed run against real-style questions with explanations that cite the FAA sources — so your weak areas show up as data, not guesses. That's what the free diagnostic is for.
See where you stand: Upward Prep's free 25-question AMG practice test mirrors the ACS subject weights, times you like the real thing, and gives cited explanations for every answer — no account needed. Try the free AMG practice test →
Frequently asked questions
are the tests to get your a&p difficult
Difficult is the wrong word; demanding is better. The AMG is 60 questions in 2 hours with a 70% pass bar (FAA-G-ACS-1 Companion Guide). The challenge is breadth (12 subject areas) and the calculation-heavy sections — basic electricity and weight-and-balance. It's a fair test: the blueprint is public, every question is independent multiple-choice, and the pacing is generous.
is it hard to pass
Passing means 42 of 60 correct — a fixed 70% standard, not a curve (FAA-G-ACS-1 Companion Guide, Ch. 3). Most candidates who prepare with the published subject weights pass; the ones who struggle are typically the ones who underestimated the electricity and weight-and-balance calculations. Two minutes per question gives you room to work problems carefully instead of rushing.
how hard is the general written
Compared to the Airframe and Powerplant writtens (100 questions each), the General is the shortest of the three (FAA Airman Knowledge Testing Matrix). It's also the first one most people take, so unfamiliarity with the test-center process makes it feel harder than it is. Structurally, it's the most passable of the three — fewer questions, same 70% bar, same generous pacing.
what happens if you fail the amg exam
You get an Airman Knowledge Test Report listing the ACS codes you missed, which tells you exactly what to restudy. You may retest 30 days after the failure, or sooner if you present a signed statement from an airman holding the certificate and rating you're seeking, certifying you've received additional instruction in the subjects you failed (14 CFR 65.19) (FAA-G-ACS-1 Companion Guide, Retests).
